![]() Click the design space pause button overlay ( ) to resume placement. Press the Tab key to pause the placement and access the Note mode of the Properties panel from where its properties can be changed on the fly.Continue placing further notes or right-click or press Esc to exit placement mode.Īdditional actions that can be performed during placement while the note is still floating on the cursor and before its first corner is anchored are:.Move the cursor to adjust the size of the note then click or press Enter to complete placement.Click or press Enter to anchor the first corner of the note.Placement is made by performing the following sequence of actions: Right-click in the design space then choose Place » Note from the context menu.Īfter launching the command, the cursor will change to a cross-hair and you will enter note placement mode.Once a command has been used, it will become the top-most item on that section of the Active Bar.) (Click and hold an Active Bar button to access other related commands. Click the Note button ( ) in the graphic objects drop-down on the Active Bar located at the top of the design space.Choose Place » Note from the main menus.Notes are available for placement in the Schematic Editor only in the following ways: The note is a resizable rectangular area that can contain multiple lines of text and can automatically wrap and clip text to keep it within the bounds of the note. It is used to add informational or instructional text to a specific area within a schematic similar to that of commenting a program's source code. Editing via the Note Dialog or Properties PanelĪ note is a non-electrical drawing primitive. ![]()
0 Comments
Leave a Reply. |